
| 输出类型 | 等效电路图 | 功能 | 端子号 | 导线颜色 |
| NPN |
| VDC + | 1 | 棕 |
| SW1(NO) | 4 | 黑 | ||
| SW1(NC) | 2 | 白 | ||
| GND(0 V) | 3 | 蓝 | ||
| PNP | ![]() | VDC + | 1 | 棕 |
| SW1(NO) | 4 | 黑 | ||
| SW1(NC) | 2 | 白 | ||
| GND(0 V) | 3 | 蓝 |
| 常开(NO)接法 | 常闭(NC)接法 | ||
|
|
|
|
Technical Specifications
| General description | |
| Measurement principle | Frequency sweep |
| Measurement hysteresis | ±1mm |
| Medium characteristics | DC≥1.5 |
Response time | 0.2s |
| Damping time | 0~5s (adjustable) |
| Repeatability | ±5mm |
| Process conditions | |
Process temperature(Standard process connection) | -40°C~+115°C |
| Process pressure(Standard process connection) | -0.1~ +10MPa |
| Other links Process conditions | See the operating conditions table |
| Process connection type | |
| type | See dimension drawing |
| Installation location | Top, bottom, side |
| Liquid-wetting material | PEEK 304 or 316L |
| Liquid-wetting surface roughness | Ra< 0.8 μm |
| Environmental conditions | |
| Protection level | IP67 |
| humidity | <98% RH ,有凝结 |
| Ambient temperature | Cable lead type: -25~70℃M12 connector type: -40~85℃ |
| Output signal | |
| Output type | NPN NO (normally open) &NC (normally closed) PNP NO (normally open) & NC (normally closed)PWM pulse width modulation outputSPST relay output |
| Output voltage drop(Typical value) | PNP:1.5 ±0.5V ,Rload=10k NPN:1.5 ±0.5V ,Rload=10k |
| Output current | 20mA (typical) 150mA (optional) |
| Leakage current | <100uA |
| Output short circuit protection | have |
| Electrical connection | |
| Connection method | M12 4-pin connector4x0.5mm² cable outlet |
| powered by | |
| Voltage range | 12~30VDC |
| Startup time | <1s |
| Supply current(No load) | 8mA (typical value) 50mA (maximum value) |
| Reverse polarity protection | have |
| Dielectric strength | 500VAC |
| Default factory settings | |
| Damping time | 0s |
| Alarm point parameter AL1 | 250 (Low dielectric constant medium)550 (Water-based medium)720 (Conductive slurry)Output alarm when PV≥WID0 |
| Measured value PV | 0~1000 100: The probe is in the air. 800: The probe is in tap water. |
| Alarm hysteresis | 25 |
| Protection function | The parameters cannot be modified before being unlocked. |
| Certification status | |
| EMI radiation | GB/T 24338.4 -2009 |
| EMC immunity | GB/T 24338.4 -2009 |
| Explosion-proof certification | Ex ia IIC T6 GaEx iaD 20 IP65 T80° |
| Hygiene certification | Compliant with FDA and AAA standards |